Land Cruiser 80 Series 45mm (2 Inch) Suspension Lift Kit - by Pedders, fits models listed.
Lifts the vehicle 45mm while keeping a more standard ride. The uprated coils are new and stiffer than original to help control body roll with the added height. Recommended for models with a standard front bumper setup.
Fits: Land Cruiser 80 Series - FZJ80, HDJ80 & HZJ80 | 1992-1998
Our Kit Contains:
For the Front:
- x2 Pedders 7702 Front Lift Coil Springs, Uprated - 187 Lbs/In, 16mm wire, 520mm F/L
- x2 Pedders Gas Trak-Ryder 9100 Series 9121 Front Shock Absorbers - 16mm pistons
- Pedders Rubber Bush Kit 5802 (Set of 4)
For the Rear:
- x2 Pedders 7745 Rear Lift Coil Springs, Uprated - 204 Lbs/In, 14mm wire, 495mm F/L
- x2 Pedders Gas Trak-Ryder 9100 Series 9122 Rear Shock Absorbers - 16mm pistons
A simple, easy-to-fit lift from the well known Australian brand Pedders. Improves looks and handling while helping to prevent body roll in bends, giving greater ground clearance for larger tyres. Ideal for occasional towing plus on- and off-road use. The uprated coils and heavy-duty twin-tube gas shocks are tried and tested in the outback - the larger-piston shocks give a slightly firmer, more responsive ride. Need more loaded capacity? We also offer a Heavy Duty version of this kit.
Fitting Tip - Only torque suspension bushes when the weight is back down on the vehicle - NOT when the suspension is hanging down. Always ensure your front wheel alignment and geometry is checked after installation. Please note: When you lift the Land Cruiser 80 Series you should also fit castor correction bushes to re-align the axle to within OE tolerance - Pedders Rubber Bush Kit 5802 (Set of 4) is included in this sale. This increases the castor angle by approx 2 degrees to correct the steering/axle angle after fitting the lift kit. As with all suspension shocks/coils supplied, paint is not covered under warranty due to the very nature and position of the component.
The Shock Tech:
The Pedders Trak-Ryder 9100 Series shock absorbers have a huge 16mm sintered hardened piston, 35mm internal bore and 54mm external bore - perfect for both general purpose road and off-road use. It uses nitrogen gas pressure to enable consistent and precise ride control without compromising on ride comfort. They feature a bearing slip ring that is said to eliminate oil bypass between the shaft and the pilot bearing. There is also an anti-bleed-back upper seal, to maintain the correct level of oil in the pressure tube at all times. The advantage of a twin tube design like the Pedders Trak-Ryder, especially in off-road conditions, is that if any large stones are flicked up off the road and dent the body of the shock absorber, it will not affect its operation. Trak-Ryder shock absorbers are a high performance, heavy duty replacement unit, delivering a new standard of comfort and road holding ability for your 4WD. Ideal for the motorist after that extra performance and sporty handling.
- Pressurised Nitrogen Gas
- 35mm Internal Bore
- 54mm External Bore
- 16mm Sintered Iron Piston
- Anti-Bleed Back Upper Seal
- Reinforced Double Welded Mountings
- Direct OE Fitment
- Heavy Duty Construction
Delivery & Dispatch:
Upgrade your Land Cruiser with high-quality Pedders Suspension from Apex4WD – order now!
PLEASE USE A QUALIFIED MECHANIC TO FIT THIS PRODUCT IF YOU ARE NOT CONFIDENT IN YOUR OWN ABILITY.
